EasyManua.ls Logo

ST B-L4S5I-IOT01A - Appendix B Federal Communications Commission (FCC) and Industry Canada (IC); Compliance Statements; FCC Compliance Statement; IC Compliance Statement

ST B-L4S5I-IOT01A
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix B Federal Communications Commission (FCC) and Industry
Canada (IC) Compliance Statements
Applicable for IoT node Discovery kit products with order code B-L4S5I-IOT01A.
B.1 FCC Compliance Statement
FCC Compliance Statement
Contains FCC ID: O7P-362
Contains FCC ID: S9NSPBTLERF
Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Part 15.21
Any changes or modifications to this equipment not expressly approved by STMicroelectronics may cause
harmful interference and void the user's authority to operate this equipment.
Part 15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception which can be determined by turning the equipment off and on,
the user is encouraged to try to correct interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note: Use only shielded cables.
Responsible party (in the USA)
Terry Blanchard
Americas Region Legal | Group Vice President and Regional Legal Counsel, The Americas
STMicroelectronics, Inc.
750 Canyon Drive | Suite 300 | Coppell, Texas 75019
USA
Telephone: +1 972-466-7845
B.2
IC Compliance Statement
IC Compliance Statement
Contains/Contient IC: 10147A-362
Contains/Contient IC: 8976C-SPBTLERF
Compliance Statement
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B) / NMB-3 (B).
UM2708
Federal Communications Commission (FCC) and Industry Canada (IC) Compliance Statements
UM2708 - Rev 1
page 36/43

Table of Contents

Related product manuals