ST LPS22HB - Mechanical Stress; Figure 9: Bad Configuration for Mechanical Stress (A); Figure 10: Bad Configuration for Mechanical Stress (B); Figure 11: Good Configuration for Avoiding Mechanical Stress and Reducing the Dead Volume (A)

Mechanical design rules
AN4672
12/24
DocID027655 Rev 3
2.1.3 Mechanical stress
The sensor placement shall avoid any mechanical force applied on the sensor, direct due
to a wrong mechanical system design, or indirect due to the user interaction with the
system like in the case of wearable or portable device.
Figure 9: Bad configuration for mechanical stress (a)
Figure 10: Bad configuration for mechanical stress (b)
Figure 11: Good configuration for avoiding mechanical stress and reducing the dead volume
(a)