ST SPC560D-DIS - Crystal Oscillator; Figure 5. Crystal (PCB); Figure 6. Reset Section; Reset Section

UM1681 Rev 3 9/23
UM1681 Hardware overview
22
2.2 Crystal oscillator
The SPC560D-DIS board could be populated either with 8 or 16MHz crystal to clock the
SPC560D40L1.
Default configuration is with 16 MHz crystal.
Figure 5. Crystal (PCB)
2.3 Reset section
In order to generate a clean reset signal for the microcontroller, STM6315RDW13F is used.
SW1 button triggers such device generating a reset signal.
D8 is powered on as soon as reset pulse is generated.
The reset signal can be propagated to the on board linear voltage regulator via
RESET_ASD line closing the jumper J14 (see Figure 3: +5 V supply section).
Figure 6. Reset section
GAPGRI00385
GAPGRI00386