Introduction
STLINK-V3MINIE is a stand-alone debugging and programming tiny probe for STM32 microcontrollers.
The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board.
STLINK-V3MINIE also provides a Virtual COM port interface for the host PC to communicate with the target microcontroller
through one UART.
STLINK-V3MINIE is a portable version easy‑to‑use debugger and programmer including STDC14 interface with its flat cable
and on‑board pads for board‑to‑board (BTB) card edge connector.
Figure 1. STLINK-V3MINIE top, bottom, and cable views
Pictures are not contractual.
STLINK-V3MINIE debugger/programmer tiny probe for STM32 microcontrollers
UM2910
User manual
UM2910 - Rev 2 - January 2022
For further information contact your local STMicroelectronics sales office.
www.st.com
To Next Page
Need help?
General
