4.2.5 Analog output gyroscopes: supported commands
Table 9. Analog output gyroscopes: supported commands list below lists the commands supported by the
devices/demonstration boards including an analog output gyroscope.
Table 9. Analog output gyroscopes: supported commands list
Command Description Returned value
*setdbXXXVY Selects firmware according to the adapter connected
*start Starts continuous data acquisition (see Table 4. Returned values for *start command)
*debug Returns the output data in readable text format (see Table 5. Returned values for *debug command)
*stop Stops data acquisition
*Zon Forces 3-state
*Zoff Exits from 3-state
*dev Device name e.g.: LIS3DH
*ver Firmware version e.g.: V1.0
*single It gets a single X, Y, and Z data acquisition (see Table 5. Returned values for *debug command)
*list Prints the list of MKIs supported e.g.: MKI105V1
*listdev Prints the list of devices supported e.g.: LIS3DH
*echoon Activates the write verbose mode e.g.: RAAhDDh
*echooff Deactivates the write verbose mode
*PDON Sets power-down pin
*PDOFF Clears power-down pin
*STON Sets self-test pin
*STOFF Clears self-test pin
*HPON Sets high-pass filter pin
*HPOFF Clears high-pass filter pin
UM0979
Supported commands
UM0979 - Rev 6
page 26/39
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.
To Next Page
Loading...
