ST STM32G4 Nucleo-64 - Mechanical Drawing; Embedded STLINK-V3 E; Figure 6. STM32 G4 Nucleo 64 Board Mechanical Drawing (in Millimeter)

6.2 Mechanical drawing
Figure 6. STM32G4 Nucleo 64 board mechanical drawing (in millimeter)
6.3 Embedded STLINK-V3E
There are two different ways to program and debug the onboard STM32 MCU:
• Using the embedded STLINK-V3E
• Using an external debug tool connected to the CN4 MIPI10 connector.
The STLINK-V3E programming and debugging tool is integrated in the STM32G4 Nucleo-64 board.
UM2505
Mechanical drawing
UM2505 - Rev 2
page 10/43