ST STM32G4 Nucleo-64 - User Manual

Introduction
The STM32G4 Nucleo-64 boards based on the MB1367 reference board (NUCLEO-G431RB, NUCLEO-G474RE) provide an
affordable and flexible way for users to try out new concepts and build prototypes with the STM32G4 Series microcontrollers,
choosing from the various combinations of performance, power consumption and features. The Arduino
™
Uno V3 connectivity
and the ST morpho headers provide an easy means of expanding the functionality of the Nucleo open development platform
with a wide choice of specialized shields. The STM32G4 Nucleo-64 boards do not require any separate probe as they integrate
the STLINK-V3E debugger/programmer. The STM32G4 Nucleo-64 boards come with the comprehensive free software libraries
and examples available with the STM32CubeG4 MCU Package.
Figure 1. NUCLEO-G474RE top view
Figure 2. NUCLEO-G474RE bottom view
Pictures are not contractual.
STM32G4 Nucleo-64 boards (MB1367)
UM2505
User manual
UM2505 - Rev 2 - April 2019
For further information contact your local STMicroelectronics sales office.
www.st.com

ST STM32G4 Nucleo-64 Specifications

General

Core	ARM Cortex-M4
Operating Frequency	Up to 170 MHz
Flash Memory	128 KB
SRAM	32 KB
Analog Input Channels	Up to 16
Analog Output Channels	2
Debug Interface	ST-LINK/V2-1
Microcontroller	STM32G4
ADC	12-bit
DAC	12-bit
Communication Interfaces	USART, SPI, I2C, CAN, USB
Operating Voltage	3.3V
Board Connectors	Arduino Uno V3

Summary

Features

Development environment

Development toolchains

Lists the recommended software development toolchains.

Quick start

Getting started

Step-by-step guide to configure and launch the demonstration application on the board.

Hardware layout and configuration

Embedded STLINK-V3 E

Drivers

Instructions for installing drivers for the STLINK-V3E debugger.

STLINK-V3 E firmware upgrade

Information on upgrading the firmware of the embedded STLINK-V3E.

Using an external debug tool to program and debug the on-board STM32

Methods for using external debug tools with the board.

Power supply

Debugging while using VIN or EXT as an external power supply

Procedure for debugging when using external power sources.

Clock sources

HSE clock (high-speed external clock)

LSE clock (low-speed external clock) - 32.768 kHz

Board functions

MCU voltage selection on VREF+

Virtual COM port (VCP): LPUART and USART

Board connectors

STLINK-V3 E USB Micro-B connector CN1

MIPI10 connector CN4

Arduino Uno V3 connectors CN5, CN6, CN8 and CN9

ST morpho connectors CN7 and CN10

STM32 G4 Nucleo-64 I;O assignment