ST STM32MP157C-DK2 - Figure 16. Arduino Connectors Pinout; Table 23. I;O Configuration of the Arduino

Figure 16. Arduino
™
connectors pinout
Table 23 describes the I/O configuration of the Arduino
™
interface.
Table 23. I/O configuration of the Arduino
™
interface
I/O
HW Configuration
PF14 - PF14 is used as ARD_A0: ADC1_IN0
PF13 - PF13 is used as ARD_A1: ADC1_IN1
ANA0 - ANA0 is used as ARD_A2: ADC1_IN6
ANA1 - ANA1 is used as ARD_A3: ADC1_IN2
PC3 SB24 ON PC3 is used as ARD_A4: ADC1_IN13 Default configuration
PF12 SB26 ON PF12 is used as ARD_A5: ADC1_IN14 Default configuration
PE7 - PE7 is used as ARD_D0: USART7_RX
PE8 - PE8 is used as ARD_D1: USART7_TX
PE1 - PE1 is used as ARD_D2: IO
PD14 - PD14 is used as ARD_D3: TIM4_CH3
PE10 - PE10 is used as ARD_D4: IO
UM2534
Arduino™ connectors
UM2534 - Rev 1
page 28/47