ST STM32MP157C-DK2 - Table 24. Pinout of the Arduino

I/O HW Configuration
PD15 - PD15 is used as ARD_D5: TIM4_CH4
PE9 - PE9 is used as ARD_D6: TIM4_CH1
PD1 - PD1 is used as ARD_D7: IO
PG3 - PG3 is used as ARD_D8: IO
PH6 - PH6 is used as ARD_D9: TIM12_CH1
PE11 - PE11 is used as ARD_D10: SPI4_NSS, TIM1_CH2
PE14 - PE14 is used as ARD_D11: SPI4_MOSI ,TIM1_CH4
PE13 - PE13 is used as ARD_D12: SPI4_MISO
PE12 - PE12 is used as ARD_D13: SPI4_SCK
PA12 - PA12 used as ARD_D14: I2C5_SDA shared with ARD_A4 (SB23 ON / SB24 OFF)
PA11 - PA11 used as ARD_D15: I2C5_SCL shared with ARD_A5 (SB25 ON / SB26 OFF)
Table 24 describes the pinout of the Arduino
™
connectors.
Table 24. Pinout of the Arduino
™
connectors
Connector
Pin name Signal name STM32 pin Comment
CN16
1 NC - NC (reserved for test)
2 3V3 - IOREF 3V3
3 NRST NRST NRST
4 3V3 - 3V3
5 5V - 5V
6 GND - GND
7 GND - GND
8 VIN Not connected
CN17
1 A0 PF14 ADC1_IN0
2 A1 PF13 ADC1_IN1
3 A2 ANA0 ADC1_IN6
4 A3 ANA1 ADC1_IN2
5 A4 PC3/PA12 ADC1_IN13
6 A5 PF12/PA11
CN14
1 ARD_D0 PE7 USART7_RX
2 ARD_D1 PE8 USART7_TX
3 ARD_D2 PE1 IO
4 ARD_D3 PD14 TIM4_CH3
5 ARD_D4 PE10 IO
6 ARD_D5 PD15 TIM4_CH4
7 ARD_D6 PE9 TIM1_CH1
8 ARD_D7 PD1 IO
UM2534
Arduino™ connectors
UM2534 - Rev 1
page 29/47