3 Breakout boards
The X-NUCLEO-53L8A1 package does not include the VL53L8 breakout boards.
You can purchase them in a pack of two PCBs as SATEL-VL53L8.
For mechanical integration purposes, it could be interesting to use the mini PCB by breaking the SATEL-VL53L8
along the red line as shown in the figure below. It is easier to integrate this setup into a customer's device thanks
to its small size.
Figure 6. SATEL-VL53L8
The SATEL-VL53L8 boards cannot be directly plugged onto the X-NUCLEO-53L8A1 through the two 6-pin
headers (see Figure 7).
They can be connected to the X-NUCLEO-53L8A1 by using the mini PCB through flying wires (see
Figure 9. VL53L8 mini PCB flying wire connection to the X-NUCLEO-53L8A1 expansion in SPI mode. J9 jumper
with pin 1 and 2 connected).
The schematic can be duplicated for the sensor on the right allowing the use of both mini PCB.
UM3120
Breakout boards
UM3120 - Rev 1
page 5/23
To Next Page
Loading...
