Stack-On QAS-450-B - Page 3

40287-1307
3
18
Repeat scanning the same nger while listening for
the single “beep” for each successful scan. As you
continue to scan, the scanner is “learning” your
ngerprint. Aer a minimum of 5 scans and possibly
many more, the safe will eventually “beep” 2 times
indicating the ngerprint has successfully been
recorded.
1. To record a ngerprint, press the Reset Buon (6)
on the inside of the safe. One “beep” will sound and
the green light will start to ash.
If the nger scan happens to fail, the red light will
ash and there will be 4 “beeps”. Continue to scan
aer the green light goes on but be aware that 3 failed
scans will result in the termination of the recording
session. You will then have to start over from step 1.
2. While the green light is ashing, slide a nger
across the scanner. When you hear a single “beep”,
the scan has been successful.
3. Repeat steps 1 and 2 to record up to 28
ngerprints. If you try to record more than 28
ngerprints, the red light will ash and there will be
4 “beeps”.
For security you must record your ngerprint.
You can record up to 28 ngerprints
RECORDING FINGERPRINTS
Reset Button
OPENING THE SAFE USING A
RECORDED FINGERPRINT
e scan has been successful if there are 2 “beep”
and the green light ashes. e safe door will open.
1. Press the START buon (2). ere will be a one
“beep” and the green light will go on.
2. Slide a recorded nger across the scanner while
the green is on.
To close the safe, push the door closed until locked.
START button
If the nger scan happens to fail, the red light will
ash and there will 4 “beeps”. Try to scan your
nger again aer the green light goes on but be
aware that 3 failed scans will result in the scanner
shuing down. You will then have to start over
from step 1.