Stairmaster TreadClimber - Page 25

13. Secure the console frame to the handrails (Fig. 13) by
loosely threading two button head cap screws trough
the rail into the console frame.
Final Torque:
o 35 In-Lbs (4.0 Nm)
Fig. 13
14. Using a torque wrench, go back to steps: 6, 8, 9, 12, &
13 to thread all bolts mentioned in each step to their
corresponding final torque (Fig. 14) specifications
which are listed in the notes section of the step
instructions.
Fig. 14
15. Hover the top half of the display (Fig. 15) over the
console frame.
Fig. 15
25