Information Window: Provides informational messages, prompts during program setup, notification when
your workout is complete, and scrolling summarized workout data during and after a workout. Depending
on the program completed and settings as set in Maintenance Settings mode, workout data may include:
Time remaining
Distance remaining - miles or kilometers
Calories expended per hour
Minutes per mile/kilometer
Vertical distance travelled - feet or meters
METS
Heart Rate
HOT BAR CONTROL FEATURES
Your Hot Bar provides you with the
following operating controls: Speed/
Incline level Button: Push “+” down on
the dual-action button or away to
increase the speed of incline level. Push
“-“ down or pull to decrease.
Stop Button: Push on the red Dual
Purpose Stop Button to stop the unit
or to reset after the emergency
lanyard has been pulled.
Pull Cord Stop
Pull Cord Stop: Clip on the Pull Cord Stop to your shirt for proper application. A tug on the cord will trip the
emergency stop switch and the TreadClimber will stop operating. Press on the red Dual Purpose Stop Button
to reset the TreadClimber.
SAFTEY FIRST
Your TreadClimber by StairMaster is equipped with an easy to reach HOT BAR that provides you with an additional
PAUSE/STOP button and a Stop Switch.
The Stop Lanyard Clip attached to the HOT BAR® is provided for your protection to stop the machine. Always attach
the Stop Lanyard Clip to your clothing before each workout. Attach it to your clothes near the waistline. If the cord is
pulled the Stop Switch will be activated and the treadmill will stop operating. If the Stop Switch has been activated,
press the smaller yellow RESET button to reset the TreadClimber by StairMaster and resume normal operation.
During use, press the red STOP button to PAUSE your workout. Press the STOP button a second time while in Pause
mode to stop and cancel the workout program.
Important: Facility owners, managers, personal trainers and personnel. Remind users of the importance of always
attaching thee Stop Lanyard Clip before operating the unit. It is the facility’s responsibility to train and instruct in the
proper use of this TreadClimber by StairMaster including use of all of the safety features.
Note: A clipping feature is provided in the display housing to store the Stop Lanyard Clip when the unit is not in use.
SAVE THIS INSTRUCTION
To Next Page
Loading...
