OPERATING INSTRUCTIONS
Operating the TREADCLIMBER® is very easy. Simply step onto the treadles, securely attach the pull cord
STOP to an article of your clothing, press QUICK START, and begin walking.
IMPORTANT: Before operating the unit, you must be familiar with the following equipment limitations and
safety features.
Maximum Weight: Your TREADCLIMBER is designed for a maximum user weight of 350 lbs/159 kg. DO
NOT exceed the maximum user weight.
STOP
SWITCH
ON / OFF POWER BREAKER
Emergency Stop: In case of emergency, press the STOP on the Hot Bar or pull the Pull Cord Stop on the
Hot Bar.
Immobilizing the Walking Belt: To power the unit, set the ON/OFF power breaker to the ON position. To
turn the unit off, set the ON/OFF power breaker to the OFF position. When the unit is turned off,
movement of the walking belt is prevented.
Safety Lockout Feature: Allows you to lock out the TreadClimber. When locked, the display shows the
message "LOCKED, ENTER ID TO UNLOCK". The user must press "0", enter a 5-digit ID number
(default=12345), then press ENTER to unlock the unit. Unit will then operate as normal (NOTE: The unit
will lock back up if it is idle for 30 seconds). Use the LOCK OUT option in MAINTENANCE SETTINGS to
enable/disable the lock out feature; use the LOCKOUT ID option to change the default ID (see Settings &
Testing).
DISPLAY CONTROL PANEL FEATURES
Your TREADCLIMBER® is equipped to provide you and your users unlimited exercise opportunities.
Experiment with its features to find the right combination for your fitness regimen. The Display panel shown
to the right provides the operating controls and display elements described in the following paragraphs:
QUICK START Key: Starts your TREADCLIMBER® moving using a default weight of 155lbs/ 70kg
and a time limit of 99 minutes. QUICK START will allow you to manually operate the unit. The
QUICK START key also serves as an “Enter” key in programming modes.
STOP Key: Pauses your workout when pressed once. Ends your workout when pressed twice.
To Next Page
Loading...