14 ► MB05 User Manual
UNDERWATER USAGE
Underwater usage of the breaker will cause damage
to internal components. Even if the breaker is partially
submerged, water is introduced to an area between the
tool bit and piston. On the piston down cycle, the water
becomes compressed and damages adjacent compo-
nents.
GREASE THE BIT
Grease should be applied to the upper end of the break-
er tool bit each time it is installed. Thereafter, the tool
should be greased at the tting to reduce wear in the
lower body and bushings of the tool. See Greasing The
Tool Bit in the sections titled Pre-Operation Procedures.
Do not use underwater without supplying air to breaker.
DO NOT USE UNDERWATER
No part of the breaker may be submerged in water.
Underwater usage of the breaker will cause
internal damage to the breaker. Consult Stanley for
modications and specic warranty coverage if you
have an underwater requirement.
OPERATION
To Next Page
Loading...
Need help?
General
