Star Micronics TSP143IIU - 10-6. Reliability

– 29 –
10. Specications
10-1. General Specications
(1) Printing method Direct line thermal printing
(2) Print speed Max. 1200 dots/sec. (150 mm/sec.)
(3) Dot density Standard 8 dots/mm (203 dpi)
(4) Printing width Max. 72 mm
(5) Roll paper Refer to chapter 5 for details on the recommended roll paper.
Paper width:79.5±0.5 mm
57.5±0.5 mm when the paper roll holder is used)
Roll diameter: ø83 mm or less
(6) Overall dimension 142 (W)
×
204 (D)
×
132 (H) mm
(7) Weight 1.72 kg (without roll paper)
(8) Noise Approx. 50 dB
Note: e noise measurements listed above were obtained ac-
cording to conditions established by this company. e
noise measurements may vary depending on the type
of paper used, type of printing and operating environ-
ment.
204 mm
132 mm
142 mm