– 11 –
ENGLISH
3-1-4. Connecting Ethernet Cable
(1) Make sure the printer is turned off.
(2)Affix the ferrite core onto the
ethernet cable as shown in the illus-
tration below.
(3) Pass the fastener through the ferrite
core.
(4) Loop the fastener around the cable
and lock it. Use scissors to cut off
any excess.
(5) Connect the ethernet cable to the
connector on the interface board.
Then, connect the other end of the
cable to your computer.
Ferrite core
Ethernet cable
10cm
(maximum)
Fastener
To Next Page
Loading...
