Star Trac 8-TRx - Page 45

Page 45
Error
Code
Name Description Diagnosis
Command
Used
10 ERR_FIT_FIFO_READ
Error reading Fit FIFO. This is reported
when the computer has an internal
error during boot up.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
computer.
DISP_ERROR
11 ERR_CV_QUEUE_CREATE
Error creating CV queue. This is report-
ed when the computer has an internal
error during boot up.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
computer.
DISP_ERROR
12 ERR_CCB_FIFO_OPEN
Error opening CCB FIFO. This is report-
ed when the computer has an internal
error during boot up.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
computer.
DISP_ERROR
13 ERR_CCB_FIFO_READ
Error reading CCB FIFO. This is report-
ed when the computer has an internal
error during boot up.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
computer.
DISP_ERROR
14 ERR_CCB_QRY_RESP_TIMEOUT
Timeout waiting for query id response
from CCB. This is reported when the
Display does not receive a query id
response from the CCB during boot up.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, check the
comms/power cable between the
Display and the CCB .
3) If the problem still persists change
the comms/power cable.
DISP_ERROR
15 ERR_CCB_READ_TIMEOUT
Timeout during EEPROM read from
CCB. This is reported when the Display
times out waiting for a read from the
EEPROM on the CCB.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, check the
comms cable between the Display and
the CCB .
3) If the problem still persists change
the comms cable.
DISP_ERROR
16 ERR_CCB_READ_FAILED
CCB reports EEPROM read failure. This
reports an EEPROM read failure on the
CCB.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
CCB.
DISP_ERROR
17 ERR_CCB_WRITE_TIMEOUT
Timeout while writing to EEPROM on
CCB. This is reported when the Display
times out waiting for a write to the
EEPROM on the CCB.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, check the
comms cable between the Display and
the CCB .
3) If the problem still persists change
the comms cable.
DISP_ERROR
18 ERR_CCB_WRITE_FAILED
CCB reports EEPROM write failure. This
reports an EEPROM write failure on
the CCB.
1) Re-boot the unit and see if the prob-
lem goes away .
2) If the problem persists, replace the
CCB.
DISP_ERROR
19 ERR_CCB_INVALID_CONFIG
Invalid cong data received from CCB.
This reports that invalid conguration
data was received from the CCB.
(This error is currently disabled and will
not be seen on any units)
DISP_ERROR
20 ERR_CCB_INVALID_STATS
Invalid stats data received from CCB.
This reports that invalid statistics data
was received from the CCB.
(This error is currently disabled and will
not be seen on any units)
DISP_ERROR