Star Trac TREADMILL User Manual (English)

Questions and Answers:

S
Sara DrakeJul 26, 2025
What to do if my Star Trac Treadmill displays 'EL STL' error?
- R
  Robert GrayJul 26, 2025
  If your Star Trac Treadmill's elevation system has malfunctioned, begin by engaging Motor Test Mode to check the elevation response and the corresponding LEDs on the MCB. If there's no LED activity or response from the elevation motor, the MCB might need replacing. Also, make sure there isn't anything blocking the elevation screws or belt. Binding elevation screws, possibly due to a lack of cleaning and lubrication, can also cause this issue. Finally, check that the elevation idler isn't loose or damaged, as this could lead to binding.
M
Michael JosephJul 30, 2025
What to do if my Star Trac displays 'NO SENSOR' error?
- R
  rperezJul 30, 2025
  If your Star Trac Treadmill displays 'NO SENSOR', it could be due to a sudden speed change detected by the RPM Sensor, a loss of speed feedback, or a loose cable. Start by engaging Motor Test Mode to check the speed response; no response indicates the RPM Sensor may need replacement. Then, check if the RPM Sensor LED on the MCB is responding; if not, the MCB may need replacing. Also, verify that the MIN SPD, ½ SPD, and MAX SPD are correctly set in Manager Mode. Finally, engage Speed Calibration; if calibration fails, the MCB may need replacement.
P
Paula BookerAug 4, 2025
What to do if my Star Trac Treadmill displays 'SPEED CHG' error?
- R
  Randy WillisAug 4, 2025
  If your Star Trac Treadmill displays 'SPEED CHG', this indicates a sudden speed change detected by the RPM Sensor or irregular speed at high or low speeds. First, engage Motor Test Mode to verify the speed response; no response suggests the RPM Sensor needs replacement. Also, check if the RPM Sensor LED on the MCB is responding; if not, replace the MCB. Verify that the MIN SPD, ½ SPD, and MAX SPD are correctly set in Manager Mode. Engage Speed Calibration; if it fails, replace the MCB. Lastly, ensure the motor brushes are secured within the motor.
J
Jennifer KennedyAug 8, 2025
What does 'EL LOST' mean on my Star Trac ?
- A
  andrewmurrayAug 8, 2025
  If your Star Trac Treadmill displays 'EL LOST', it means the elevation motor readings are out of range or the reading is lost. Combine Motor Test Mode with Elevation Calibration to verify that the elevation motor readings are within range. Check that the Elevation Motor Range changes in increments of 1% as the treadmill elevates up and down; erratic increments indicate a faulty display cable or elevation motor.
J
Johnny PenningtonAug 12, 2025
How to fix 'EL RANGE' error on Star Trac ?
- H
  Hannah ThomasAug 12, 2025
  If your Star Trac Treadmill displays 'EL RANGE', it indicates that the elevation motor readings are outside the acceptable range. To resolve this, engage the Elevation Calibration feature and verify that the elevation motor readings fall within the specified range.
A
arnoldwendyAug 16, 2025
What to do if my Star Trac displays 'KEY DN'?
- E
  edwardporterAug 16, 2025
  If your Star Trac Treadmill displays 'KEY DN', it means one or more keys on the display panel are either faulty or stuck. To troubleshoot this, engage the Display Test and check the keypad response.