– 14 –
4. Attaching the Accessories
The following accessories do not necessarily have to be attached.
Attach them if necessary.
• Holding plate
• Rubber feet
• Switch cover
4-1. Attaching the Holder Plate
(1) Attach the holding plate to the printer. Then tighten
the two screws that were supplied to secure it in
place.
(2) Position the printer over the screws, etc., on the wall
and then slide it downward to set it in place.
(3) Push the cover open lever, and open the printer
cover.
(4) Insert the roll paper as shown.
To Next Page
Loading...
