13
Power on
Pick up the sled on your arm or use the
padded dock’s balance pin.
With the post vertical, ip the pause switch to
ON and the Volt becomes active.
The green LEDs glow.
You should now feel the horizon assistance
and articial bottom-heaviness of normal
mode.
The Volt only needs to have the post encoder
aligned when powering on.
Pausing and activating the Volt can be toggled
with the handle in any orientation.
If you do power down, remember to align the
handle again when powering back up.
Powering on the system sets the roll and tilt
trims to default horizon for a vertical post
with level tilt head.
In the next section, we’ll explore trimming
and modes.
To Next Page
Loading...
