18
Operating
The included padded dock is essential to protect
the Volt’s motors and electronics. Other methods
of docking may damage the unit.
Always use the over-center hook while docked.
TIP: You can remove unnecessary docking rings
from your post and gain precious gimbal height!
The dock offers the ability to tilt the gimbal up to
30˚ while remaining docked and secure.
To enable this feature, remove the set screw from
beneath the stand mount with a 1/8” Allen key.
Tilt angle is now secured with the tilt lock knob
pictured.
TIP: Instead of using the tilt dock for lock-off
shots, you can also place the rig on the balance
stud and engage the Volt motors.
Setting trim will hold the shot with next to no
operating required!
To Next Page
Loading...
