17
Operating
Should you wish to set the ROLL trim, SHORT-
press the trim button on the control box and
position the sled to the new level position while
the LEDs blink for 5 seconds.
When LED blinking stops, your new horizon
position (or Dutch angle) is now stored in
memory.
To reset the roll horizon to default, LONG-
press the trim button on the control box for 6
seconds until both LEDs on the control box turn
off and pulse back on.
Horizon is now reset.
Any previous TILT trim will be maintained.
Quick low mode is now easier than ever!
When ipping, there is no need to re-balance
because the sled is neutral.
Simply invert the sled and rotate the monitor
for viewability.
NOTE: If you tilt the head, make
sure to set a new trim.
To Next Page
Loading...
