20
OPERATING INSTRUCTIONS
NOTE:
1.Press “ ” during exercise, speed will decrease to “0”,
but elevation will not change. After treadmill belt has stopped,
the information window for ( TIME, HEART RATE, CALORIES,
then PACE, DISTANCE, AVG SPEED) will rotate between values
every 5 seconds, a large STOP will show in the dot matrix. This
is telling you to press the “ ” to reset treadmill last user
information. If the user presses “ ” before “ ”,
routine will begin at minimum speed, and routine will “Add” to
the exercise values displayed.
2.Pressing “ ” during a routine will begin slowly decreasing
speed and elevation until minimums are reached, and then belt
stops. After belt stops, user and restart by pressing “ ”
or press “ ” to reset.
3.Press “ ”, when asked in the scrolling display to enable
elevation / incline.
STOPSTOP
STOP
STOP
START
START
STOP
COOL
DOWN
HEART RATE CONTROL
To Next Page
Loading...
