40
OPERATING INSTRUCTIONS
ERROR CODE
1. When pressing “ ” , speed and elevation decrease to 0
slowly.
2. When pressing “ ”, speed decrease to 0 MPH,
but elevation will not change.
3. All exercise information will be kept for 5 minutes after
exercising. After 5 minutes, it will turn to standby mode.
4. Under standby mode, if no operation in 5 minutes, it will turn
to sleep mode which turns off display. Press any button to
leave sleep mode.
ERROR CODE
1. When the display shows E1, indicates Drive Motor Error.
2. When the display shows E6, indicates an elevation motor signal
error.
3. When the display shows E7, indicates elevation moto error.
4. When the display shows USB ERR, USB is not detected.
5. When the display shows USB DATA ERR, it means USB format
mistake. Please re-check if data format is correct.
COOL
DOWN
To Next Page
Loading...
