INSSTCP5MA0116
13
Copy of the Programming
You can apply the programming of one day of the week to other
days by copying the programming day by day or in block.
To copy the programming day by day, you must:
1. Press down the source day button (day to be copied).
2. Hold down this button and press down the destination days
one by one. The screen displays the selected days. If an
error occurs when you are choosing a day, press down the
erroneous day again to cancel the selection.
3. After all selections are completed, release the source day
button. The selected days have the same programming as
the source day.
To copy the programming in block, you must:
1. Press down the source day button, hold it and press down
the last day of the block you want to copy.
2. Hold down these two buttons for 3 seconds. After this time,
the days of the block are displayed indicating that the copy
in block is activated.
3. Release the buttons. The days of the block are not displayed
anymore and the current day is displayed.
N.B. The block order is always increasing. For example, if the
source day is Thursday and the destination day is Monday, the
copy will only include Friday, Saturday, Sunday and Monday.
Erasing of the Programming
You must proceed as follows to erase a programming period.
1. Access the Programming mode as described previously
by pressing down the button corresponding to the day to
modify. Select the period to erase using the + or - button.
2. You do not have to press down the Mode button to conrm
the selection. However, doing so will not impact on the
erasing.
To Next Page
Loading...
