Stelpro STCP - Manual Mode (Man)

INSSTCP5MA0116
9
At any time, you can exit the adjustment mode of the day and
the hour by pressing down the Exit button or by not pressing
any button during 1 minute.
In case of a power failure, the thermostat is self-sufcient for
2 hours. If the failure lasts less than 2 hours, the thermostat
saves the adjustment of the hour and the day of the week.
When the power is restored after an extensive failure (more
than 2 hours), the hour and the day of the week are recovered,
but you must update them.
Display in Degrees Celsius/Fahrenheit
The thermostat can display the ambient temperature and
the set point in degrees Celsius (standard factory setting) or
Fahrenheit.
Adjustment procedure for degrees Celsius/Fahrenheit
display.
1. To switch from the degrees Celsius to the degrees
Fahrenheit, and conversely, simultaneously press down the
+ and - buttons for more than 3 seconds until the
icon
blinks.
2. Press down the + button to switch from the degrees Celsius
to the degrees Fahrenheit, and conversely. The degree
Celsius or Fahrenheit symbol is displayed.
3. When the adjustment is completed, press down the Exit
button or do not press down any button during 5 seconds to
exit the adjustment function.
This adjustment can be done from any of the three principal
modes.
Manual Mode (Man)
From the Manual mode, you can manually adjust the thermostat
set point by pressing down the + or - buttons to increase the
value, or to decrease it. Please note that if the backlight is off,
the set point will not change when you press down these buttons