Stelpro STCP - Mode Switching and Safe Mode

INSSTCP5MA0116
16
2. Choose the period number (1 to 2) to view using the +
or - button. For each period, the hour and set point are
displayed. You can also press down the Mode button to
switch to period 2. If you press down the Mode button when
period 2 is displayed, you exit the View mode.
At any time, you can exit the View mode using one of
these 3 methods.
1- Press down the button of the day you are viewing.
2- Press down another day to view it.
3- Press down the Exit button.
If you do not press down any button during 1 minute, the
thermostat quits the view mode. At any time, it is possible to
change the day to be viewed by pressing down the desired day
button.
/ Mode
To switch from the mode to the mode, or conversely,
press down the A/F button (when you are not in any adjustment
mode). The previous temperature set point of this mode will be
restored. If a set point is programmed for the current period, it
will take this value.
Safe mode
If the thermostat fails to detect the presence of a oor sensor, it
will automatically revert to mode at a set point of 21°C. (with
a maximum set point temperature of 24°C.)
Sensor Selection
If you want to use the STCP thermostat of Stelpro with a
temperature sensor already installed in the oor (other than
the sensor supplied with this thermostat), you must contact the
Stelpro customer service to validate the compatibility between
the sensor and the thermostat. You must know the serial
number and name of the installed sensor.