INSSTCP15MA0116
15
1. Press down the Pre Prog button.
2. The Pre Prog icon and saved selected preprogramming are
displayed. This preprogramming can range between 0 and
Z1.
3. From the Pre Prog mode, you can choose the rst 10
preprogrammings by pressing and releasing the Pre
Prog button. Each time you press down the button, the
preprogramming switches (from 0 to 9).
4. To choose advanced preprogrammings, (see appendix 1),
press down the Pre Prog button during 5 seconds. The letter
indicator blinks and you can adjust it by pressing down the +
or - button. Once the letter is chosen, you must validate your
choice by pressing down the Mode button. The letter ceases
to blink and the gure starts to blink. The choice of the gure
is made in the same way as that of the letter (using the + or
- button). Once the gure is selected, you must validate your
choice by pressing down the Mode button.
N.B. If you do not press down any button for more than one
minute or press the Exit button, the thermostat exits the
adjustment function and saves the current choice. Then,
the icons cease to blink and the letter and the gure
corresponding to the selected preprogramming blink
alternately until you select another preprogramming. If the
Pre Prog mode is activated and you successively press
down the Pre Prog button, the preprogramming comes
back to 0 and increases normally, as described above.
View of the Preprogramming
The view of the selected preprogramming is made in a way
similar to the Auto mode programming. However, it is impossible
to modify the preprogramming.
You must proceed as follows:
1. Press down the button corresponding to the day to view
(buttons Mon to Sun). When the selected day is displayed, the
icon and period number blink;
To Next Page
Loading...
