EasyManuals Logo
Home>STEMME>Aircrafts>S6

STEMME S6 User Manual

STEMME S6
215 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #159 background imageLoading...
Page #159 background image
FLIGHT MANUAL TSA-M, VARIANT S6
Doc.-No.: P400-006.000 E Page: 7-4 Revision: ---
Date of Issue: 07. October 2008 Date of Rev.: --.--.----
7.2 Airframe _______________________________________
7.2.1 Fuselage
The front section of the fuselage including the cockpit is constructed from
carbon-fiber-composites. For additional stiffness and a decrease in mass, it is
reinforced with longitudinal-stringers and circular-frames. The mid-section is
made of a steel-tube-framework with fairings made of carbon-fiber-composites.
The rear section with integrated vertical fin is also made of carbon-fiber-
composites. The force transmission between the separate fuselage-sections is
realised with pin joints.
For reasons of fire-containment, the engine is completely encased in fire-
resistant walls. Certain elements can easily be removed for maintenance.
7.2.2 Wing-System
The complete wing-system has a span of 59 ft / 18 m and is made of 5 separate
sections. These are one inner-wing, left and right outer-wings and two winglets.
An integral-tank for fuel is located in the forward area of the right inner-wing (an
optional second tank can be installed in the left inner-wing). The air-brakes are
located in the inner section of the outer-wing.
The wing-spars of all wing-sections are made completely of carbon-fiber-
composites. The wing-shells are made of CFC-Sandwich-elements.
The connection between the inner-wing and the fuselage is realised by four pins
which attache the wings to the steel-tube-framework.
The outer-wings are connected to the inner-wing by one socket-pin at each
wing-joint and two shear-force-fittings at each wing-root. Additional details can
be taken from chapter 4 „Normal Operating Procedures“.
7.2.3 Empennage
The T-shaped tail is also made of spars and sandwich-shells made of carbon-
fiber-composites. This set-up is similar to the wing-system. The horizontal-
stabilizer can easily be removed from the vertical-stabilizer. It is connected by a
removable three-point-mounting. To protect the tail against unwanted tail-strikes
(when rotating or in ground operations), it is equipped with a tail-skid.

Table of Contents

Other manuals for STEMME S6

Questions and Answers:

STEMME S6 Specifications

General IconGeneral
BrandSTEMME
ModelS6
CategoryAircrafts
LanguageEnglish

Related product manuals