Operating the machine
31.10.2002 \\Docuserver\ba\Master\Ba_eng\UM\044_60\UM_A+S\Bedien.fm 15
VCM 44
5.3.2 Keypad Lock
The timer has a keypad lock function accessible on the front panel.
To actuate the lock, make sure that the display shows the actual value, then press and hold
the ent key for 5 seconds.
The setpoint and pulse lenght value can be displayed while the keypad is locked by using the
set key as dicribed previously.
When either of these setpoints is displayed with the keypad lock on, the least significant digit
at the right of the display will flash in cursor fashion. However, the keypad lock disables the
position, up and down keys so that no changes can be made.
To unlock the keypad, make sure the display is showing the actual value, then press and hold
the the ent key for 5 seconds.
5.4 Mechanical product treatment.
5.5 Discharging the machine
What should happen What to do Key The result!
Process product mechanically, i.e.
slice, cut, mix, stir, emulsify, etc.
Switch on main motor
Turn mixing baffle slowly clockwise
manual
Product circulates to the
working insert
If work is done under pressure or vacuum conditions you must equalize pressure via
the aeration valve. Check the vacuum manometer to ensure that the machine is no
longer under pressure before opening the machine lid.
What should happen What to do Key The result!
Manual discharging via opened lid. Unlock toggle seal
Open lid
Tip container
manual
Remove remains with a spatula. Watch out for hidden
knives.
To Next Page
Loading...