Steren COM-820 - To Setup a Virtual Server Entry

Service Port - The numbers of External Ports. You can
type a service port or a range of service ports (the format
is XXX – YYY, XXX is the start port, YYY is the end port).
IP Address - The IP Address of the PC providing the
service application.
Protocol - The protocol used for this application, either
TCP, UDP, or All (all protocols supported by the router).
Status - The status of this entry either Enabled or
Disabled.
To setup a virtual server entry:
1.- Click the Add New button.
2.- Select the service you want to use from the Common
Service Port list. If the Common Service Port list does not have
the service that you want to use, type the number of the service
port or service port range in the Service Port box.
3.- Type the IP Address of the computer in the Server IP Address
box.
4.- Select the protocol used for this application, either TCP or
UDP, or All.
5.- Select the Enable checkbox to enable the virtual server.
6.- Click the Save button.
ENGLISH
ENGLISH-43