AC power socket: only use the power adapter supplied with the
Wireless Router, use of a different adapter may result in product
damage.
CONNECTING THE ROUTER
System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable modem that has an RJ45 connector (you do not
need it if you connect the router to Ethernet)
Each PC on the LAN needs a working Ethernet Adapter and an
Ethernet cable with RJ45 connectors
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later,
Netscape Navigator 6.0 or later
INSTALLATION ENVIRONMENT REQUIREMENTS
Not in direct sunlight or near a heater or heating vent
Not cluttered or crowded. There should be at least 2 inches of
clear space on all sides of the router
Well ventilated (especially if it is in a closet)
Operating temperature: 32°~104°F
Operating Humidity: 10%~90%RH, Non-condensing
CONNECTING THE ROUTER
Before you install the router, you should connect your PC to the
Internet through your broadband service successfully. If there is
any problem, please contact your ISP. After that, please install
the router according to the following steps. Don’t forget to pull
out the power plug and keep your hands dry.
ENGLISH
ENGLISH-5
To Next Page
Loading...
Need help?
General
