REMOTE MANAGEMENT
You can confi gure the Remote Management function on this
page shown in fi gure 51. This feature allows you to manage your
Router from a remote location, via the Internet.
- Web Management Port - Web browser access normally uses
the standard HTTP service port 80. This router’s default remote
management web port number is 80. For greater security, you
can change the remote management web interface to a custom
port by entering that number in this box provided. Choose a
number between 1024 and 65534, but do not use the number of
any common service port.
- Remote Management IP Address - This is the current address
you will use when accessing your router from the Internet. The
default IP Address is 0.0.0.0. It means this function is disabled.
To enable this function, change the default IP Address to another
IP Address as desired.
To access the router, you will type your router’s WAN IP Address
into your browser’s Address (in IE) or Location (in
Navigator) box, followed by a colon and the custom port
number. For example, if your Router’s WAN address is
202.96.12.8 and you use port number 8080, enter in your
browser: http://202.96.12.8:8080. You will be asked for the
router’s password. After successfully entering the password, you
will be able to access the router’s web-based utility.
Be sure to change the router’s default password to a very
secure password.
Fig. 51
Be sure to chan
To Next Page
Loading...
Need help?
General
