Steris LED202 - Page 28

10 — Appendix
25
11042437_A
LED202 In-Ceiling Lighting System Operator Manual
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
The STERIS Corporation LED202 SYSTEM, models LED202X2 and LED202X1 is intended for use in the electro-
magnetic environment specified below. The customer or the user of the STERIS Corporation LED202 SYSTEM,
models LED202X2 and LED202X1 should assure that it is used in such an environment.
Immunity test
IEC 60601 4th Edition
Test Level
Compliance
Level
Electromagnetic Environment – Guidance
Conducted RF
IEC 61000-4-6
Radiated RF IEC
61000-4-3
3 Vrms
0.15 MHz-80MHz
6 Vrms in ISM and
amateur radio bands
between 0.15 MHz and
80 MHz 80% AM at 1
kHz
3 V/m
80 MHz to 2.7 GHz
3 Vrms
0.15 MHz-
80MHz
6 Vrms in ISM
and amateur
radio bands
between 0.15
MHz and 80
MHz 80% AM at
1 kHz
3 V/m
80 MHz to 2.7
GHz
Portable and mobile RF communications
equipment should be used no closer to any part of
the STERIS Corporation LED202 SYSTEM, models
LED202X2 and LED202X1, including cables, than
the recommended separation distance calculated
from the equation applicable to the frequency of
the transmitter.
D= (3.5/10) √P 80 MHz to 800 MHz
D= (7/10) √P 800 MHz to 2.7 GHz
where P is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey, a
should be less than the compliance level in each
frequency range. b Interference may occur in the
vicinity of equipment marked with the following
symbol:
NOTE: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE: These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with
accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured field strength in the location in which the STERIS Corporation LED202
SYSTEM, models LED202X2 and LED202X1 is used exceeds the applicable RF compliance level above, the STERIS
Corporation LED202 SYSTEM, models LED202X2 and LED202X1 should be observed to verify normal operation. If
abnormal performance is observed, additional measures may be necessary, such as re-orienting or relocating the
STERIS Corporation LED202 SYSTEM, models LED202X2 and LED202X1.