8.3 SELF HELP GUIDE
If a system trip occurs you can find out what has
happened by checking the scooter display.
Elite
2
PLUS - counting the number of bars on the battery
gauge that are flashing.
Go to the number on the list which matches the number
of flashing bars and follow the instructions.
FAULT CODES AND POSSIBLE CAUSES.
ELITE
2
PLUS ELITE
2
XS - RS
An excessive voltage has been applied to the Power Module.
Check the battery connections.
Check the correct battery charger is being used and that it is functioning properly.
The parking brake has a bad connection.
Check all connections between Motor, Brake and Power Module.
A general control system fault has been detected.
Check that all plugs and sockets are connected.
If the scooter has been driven in extreme weather, gone through a deep puddle or
has been jet washed, place it in a dry warm environment to dry out.
A throttle fault has been detected.
Ensure that the throttle levers are at the neutral or rest position.
The scooter is being prevented from driving by the control system because
of an inhibit signal..
Check that the charger plug is disconnected from the charge socket.
This is not used.
The freewheel lever/switch is activated.
Switch the scooter off, put the scooter back into “DRIVE” mode and switch the
scooter back on again.
The Motor has a short circuit to a battery connection.
Contact your servicing agent.
There is a bad connection to the Motor.
Check all connections to the Motor and Power Module.
Check Motor brushes.
The battery needs charging or there is a bad connection to the battery.
Charge the batteries.
Check the connections to the batteries are tight.
Check the battery charger is switched on and working.
Batteries need changing.
Elite
2
XS, RS – check the error code displayed on the
LCD screen.
Go to the number on the list which matches code and
follow the instructions.
Slow or sluggish movement - If the scooter does not
travel at full speed or does not respond quickly enough
and the battery condition is good, check the maximum
speed setting. If adjusting the speed setting does not
remedy the problem then there may be a non hazardous
fault. Consult your Sunrise Medical authorised dealer.
To Next Page
Loading...
