COMMISSIONING
General information
www.stiebel-eltron.com WPM | 3
1. General information
These instructions are intended for qualified contractors.
1.1 Relevant documents
WPM operating instructions
Heat pump operating and installation instructions
Operating and installation instructions for system
components
WPM system notification list
Note
Please see device's operating instructions for information
on the "Guarantee" and "Environment and recycling".
1.2 Safety instructions
1.2.1 Structure of safety instructions
!
KEYWORD Type of risk
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
Symbol Type of risk
Injury
Electrocution
1.2.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-seri-
ous or minor injury.
1.3 Other symbols in this documentation
Note
General information is identified by the adjacent symbol.
Read these texts carefully.
Symbol Meaning
Material losses
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
These symbols show you the software menu level (in
this example level3).
1.4 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
2.1 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
2.2 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
2.3 Notes
- The appliance should only be operated once it is fully in-
stalled and all safety equipment has been fitted.
2.4 Test symbols
See type plate on the appliance.
!
!
COMMISSIONING