STIEBEL ELTRON WPM Commissioning

COMMISSIONING
Appliance compatibility
www.stiebel-eltron.com WPM | 5
3.1.3 Internet Service Gateway ISG
PIC00001002
The Internet Service Gateway (ISG) is an Ethernet gateway in a
wall mounting enclosure and is connected into the LAN (local
area network).
The device enables the operation, adjustment and checking of heat
pump system data via the browser of a computer, laptop or tablet
in the local home network.
If the customer so wishes, data from the device can be transferred
to our SERVICEWELT portal automatically over the internet.
3.1.4 WPE heat pump extension
PIC00006037
The WPEheat pump extension supplements the WPM system with
additional functions. These additional functions can be adjusted
on the programming unit of the WPM heat pump manager.
The WPEheat pump extension provides:
- Two additional heating circuits with mixer
- A swimming pool controller for primary and secondary inte-
gration of a swimming pool
- Two additional 0...10V interfaces
- Two differential controllers
- Switching outputs
The WPEheat pump extension:
- Allows cascades of up to six heat pumps
- Supplements the basic functions of the WPMheat pump
manager with options for connecting a building management
system
3.1.5 EASYTRON Connect
PIC00007409
The EASYTRONConnect system is designed for individual room
control of heating systems in buildings. The system can be con-
nected to a heat pump via ISGweb or operated independently.
Connecting the system to a heat pump enables demand-depend-
ent individual room control. Operation can be via the EASYTRON
Connect app.
If the system has an integral heat pump, the following functions
are possible:
- The system can optimise heat pump heating curves for the
connected heating circuits.
- The system can open all heating circuits for heat pump
defrost.
- The system enables the identification of rooms to be cooled
by the heat pump.
The system can be used for heating systems with wall mounted
radiators or underfloor heating. If the heating system has an in-
tegral DHW cylinder, the system can influence DHW heating.
The system can control 24 rooms. In each room, max. four ac-
tuators for radiators or channels for underfloor heating can be
controlled.
In conjunction with a control unit for underfloor heating, one room
temperature sensor is required per room.
4. Appliance compatibility
Note
Some heat pumps should not be connected directly to the
heat pump manager.
 With these heat pumps, use an indoor unit in which
the heat pump manager is factory-fitted.
 Observe the information in the heat pump documen-
tation.

STIEBEL ELTRON WPM Specifications

General

Brand	STIEBEL ELTRON
Model	WPM
Category	Heat Pump
Language	English