10
English
BT 360
Fitting the Throttle Cable
: Slip the spring (12) over the nipple
(13) on the throttle cable.
: Attach the nipple to the lever (14) on
the carburetor.
: Push the spring (12) against the
lever.
: Pass the throttle cable through the
guide (15).
: Press the throttle cableās end sleeve
(16) into the guide (15) ā use a
screwdriver or other suitable tool if
necessary.
: Fit the throttle cable nipple in the
recess at the back of the throttle
lever.
: Position the throttle cable in the
guide.
: Push the end sleeve (24) into its
seat (25) on the throttle cable.
: Secure the throttle cable (26) to the
handlebar with two cable ties (27).
Your engine requires a mixture of
gasoline and engine oil.
The quality of these constituents and the
mix ratio have a decisive influence on
the function and service life of the
engine.
Unsuitable fuels or lubricants or mix
ratios other than those specified
may result in serious damage to the
engine (piston seizure, rapid rate of
wear, etc.).
Gasoline
Use only high-quality mid-grade
gasoline with a minimum octane rating
of 90. If the octane rating of the mid-
grade gasoline in your area is lower, use
premium fuel ā leaded or unleaded.
For health and environmental
reasons, you should give
preference to unleaded gasoline.
If your machine is equipped with a
catalytic converter, you must use
unleaded gasoline.
A few tankfuls of leaded gasoline
will greatly reduce the efficiency of
the catalytic converter.
16
15
441BA012 KN
12 13
14
441BA013 KN
24
25
26
27
Fuel