19BT 360
English
: Rectify the problems which have
caused fouling of spark plug:
– To much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
: Fit a new spark plug after
about 100 operating hours – or
sooner if the electrodes are badly
eroded.
Install only suppressed spark plugs
of the type approved by STIHL –
see "Specifications".
To reduce the risk of arcing
and fire:
: If the spark plug comes with a
detachable adapter nut (1), screw it
on firmly.
On all spark plugs:
: Always press the boot (2) firmly on
to the spark plug (3).
Use a mildly alloyed gear oil (see
"Special Accessories") for lubrication of
the gearbox.
Checking Oil Level
: Check the oil level regularly – once
a week in normal operating
conditions.
: Remove the auger.
: Position the gearbox vertically so
that the drilling spindle is horizontal
and the throttle trigger is at the top.
: Take out the inspection plug (1) – if
the oil level does not come up to the
bottom edge of the hole, take out
the filler plug (2) and top up with oil
until it reaches the bottom edge of
the inspection hole.
: Fit inspection and filler plugs with
sealing rings and tighten down
firmly.
1
000BA045 KN
3
000BA050 KN
2
Gearbox Lubrication
2
441BA028 KN
1
To Next Page
Loading...
