Stihl BT 360 User Manual

12
English
BT 360
: Before fueling, clean the filler cap
and the area around it to ensure that
no dirt falls into the tank.
: Position the unit so that the filler cap
is facing up.
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
After fueling, tighten down the filler
cap by hand as securely as
possible.
* see "Guide to Using this Manual"
Replacing the Fuel Pickup Body
: Install a new pickup body every 12
months:
: Drain the fuel tank.
: Use a hook to pull the fuel pickup
body out of the tank and take it off
the hose.
: Push the new pickup body into the
hose.
: Place the pickup body in the tank.
To reduce the risk of serious
accidents and injury never start the
engine with the auger in the spindle.
: Place the machine on the ground so
that it rests on the handle frame with
the throttle lever at the top. Both
operators must hold the handlebar
steady and secure it by putting one
foot through each end of the
handlebar and pressing down.
Fueling
441BA003 KN
441BA004 KN
Starting / Stopping the
Engine
441BA014 KN

Stihl BT 360 Specifications

General

Engine Type	2-stroke
Drill Speed	200 rpm
Sound Power Level	107 dB(A)
Displacement	60.3 cc
Power Output	3.9 kW