22
English
BT 360
: When the starter rope is fully
extended it must be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of rope off the rotor.
: Fit the fan housing.
Replacing the rewind spring
: Remove the rope rotor as described
under "Replacing the starter rope".
: Remove the screws from the fan
housing, take out the spring housing
and parts of the old spring.
: Install the new spring housing –
bottom plate upwards – engage
outer spring loop on lug.
: Refit the rope rotor.
: Tension the rewind spring.
: Fit the fan housing.
: If the spring pops out and uncoils,
refit it in the counterclockwise
direction, starting outside and
working inwards:
For periods of about 3 months or longer:
: Remove the drilling tool.
: Drain and clean the fuel tank in a
well-ventilated area.
: Dispose of remaining fuel and
cleaning solution properly in
accordance with local
environmental requirements.
: Run the engine until the carburetor
is dry, this helps prevent the
carburetor diaphragms sticking
together.
: Thoroughly clean the machine, pay
special attention to the cylinder fins
and air filter.
: Store the machine in a dry, high or
locked location – out of the reach
of children and other unauthorized
persons.
441BA033 KN
Storing the Machine
To Next Page
Loading...
Need help?
General
