21BT 360
English
: Thread the new starter rope (see
"Specifications“) through the top of
the grip and the rope bush (9).
: Pull the rope through the rotor
secure it with a simple overhand
knot.
: Push the the rotor onto the starter
post – turn it back and forth until the
rewind spring anchor loop engages.
: Refit the pawl (6) in the rope rotor.
: Fit the washer (5) on the starter
post.
: Use a screwdriver or suitable pliers
to fit the spring clip (3) on the starter
post and over the guide peg on the
pawl – the spring clip must point
clockwise, as shown in the
illustration.
Tensioning the rewind spring
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
: Hold the rotor steady – straighten
the twisted rope – release the rotor.
: Let go of rope slowly so that it winds
onto the rotor.
: The starter grip must be firmly
seated in the rope guide bush.
If the grip droops to one side: Add
one more turn on rope rotor to
increase spring tension.
328BA033 KN
3
5
441BA031 KN
6
441BA032 KN
To Next Page
Loading...
