Stihl BT 360 User Manual

14
English
BT 360
When engine begins to fire:
: Push in the choke knob and
continue cranking.
As soon as the engine runs:
: Immediately move the throttle lever
back to the idle position – the engine
will settle down to idling speed.
Make sure the carburetor is
correctly adjusted – the drilling
spindle must not rotate when the
engine is idling.
The machine is now ready for operation.
To shut down the engine:
: Move the stop switch (2) to "STOP"
At very low outside temperatures:
Allow engine to warm up.
If engine doesn't start:
If you did not push in the choke knob
quickly enough after the engine began to
fire, the combustion chamber is flooded.
: Pull off the spark plug boot.
: Unscrew and dry off the spark plug.
: Set the stop switch to "STOP".
: Crank the engine several times with
the starter to clear the combustion
chamber.
: Refit the spark plug and connect the
spark plug boot,
: Move the stop switch away from
"STOP".
: Push in the choke knob – even if the
engine is cold.
: Now start the engine.
If fuel tank has been run until dry and
then refueled:
: Pull the starter rope several times to
prime the fuel system.
441BA018 KN
441BA019 KN
2
441BA020 KN

Stihl BT 360 Specifications

General

Engine Type	2-stroke
Drill Speed	200 rpm
Sound Power Level	107 dB(A)
Displacement	60.3 cc
Power Output	3.9 kW