Stihl FC 83 - Component Installation; Mounting Loop Handle

14
english / USA
FC 83
: Always walk forwards when cutting,
do not pull the unit towards you.
: Cut at a steady pace to avoid having
to make several passes.
1 = Gunning sight for cutting blade.
: Fit the loop handle (1) on the drive
tube 8" / 20 cm (A) forward of the
control handle (2)
: Position the clamp (3) against the
drive tube and slide it into the loop
handle.
: Fit square nut (4) in the loop handle,
insert the clamp screw (5) from the
other side and tighten down
securely.
Adjusting loop handle to most
comfortable position:
: Release clamp screw (5).
: Move the loop handle along the
drive tube as required - retighten the
clamp screw.
245BA009 KN
1
Mounting the Loop Handle
3
355BA030 KN
1
2
A
343BA023 KN
5
4
50 mm
( 2" )