Stihl FS 510 C-M - Mounting Brush Knives

FS 510 C-M, FS 560 C-M
English
24
N Place the cutting attachment (3) in
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
N Fit the 60-mm diameter thrust
washer (4) – convex side must face
up.
N Fit the 80-mm diameter rider plate
(5).
N Block the drive shaft.
N Screw on the nut (6)
counterclockwise and tighten it
down firmly.
Removing the cutting attachment
N Block the drive shaft.
N Unscrew the mounting nut (6)
clockwise.
N Pull the cutting attachment with its
mounting hardware off the gearbox.
Mounting Brush Knives
N Check that the deflector on the
machine is approved for brush
knives – if not, perform the next two
steps.
N Remove grass shield with thrust
plate – if fitted.
N Remove the non-approved
deflector.
N Mount deflector for grass cutting
blades and brush knives.
N Use the 65-mm diameter thrust
plate.
Brush knives 305-2 (1) and 350-3(2)
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
N Place the cutting attachment (3) in
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
N Fit the 70-mm diameter thrust
washer (4) – convex side must face
up.
N Fit the guard ring (5) for brush
knives – opening must face up.
N Block the drive shaft.
N Screw on the nut (6)
counterclockwise and tighten it
down firmly.
a
002BA469 KN
b
4
5
3
6
1
2
681BA187 KN
3
002BA494 KN
3
6
4
b
a
5