0458-662-0121-A
15
English
6 Charging the Battery, LEDs
► If a metal cutting attachment is used: Mount the barrier
bar, @ 7.2.
► Mount mowing head or metal cutting attachment, @ 7.5.1
or @ 7.6.1.
► Fit and adjust the carrying system, @ 8.2.
► Balance the brushcutter, @ 8.3.
► Adjust the loop handle, @ 8.1.
► Check the controls, @ 11.1.
► If 3 LEDs flash red while you are checking the controls:
Remove the battery and contact your STIHL dealer for
assistance.
The brushcutter has a malfunction.
► If you cannot carry out this work: Do not use your
brushcutter and contact your STIHL dealer for assistance.
6.1 Charging the Battery
The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2 Displaying State of Charge
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
► If the LEDs glow or flash red: Troubleshooting, @ 19.
Malfunction in trimmer or battery.
7.1 Mounting the Loop Handle
► Switch off the brushcutter and remove the battery.
6 Charging the Battery, LEDs
7 Assembling the Trimmer
1
0000-GXX-1248-A0
20-40%
40-60%
60-80%
80-100%
0-20%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
