FSA 90 R
English
16
Placing Power Tool on the Ground
N Move the retaining latch to ƒ and
remove the battery.
N Position your power tool so that the
cutting attachment mounting face is
pointing up.
Mounting the Fanwheel
The machine comes standard with a
fanwheel.
N Push the fanwheel (1) onto the
shaft (2).
NOTICE
The fanwheel is necessary for mounting
cutting attachments.
Blocking the Shaft
The output shaft (2) must be blocked
with the stop pin (6) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
N Push the stop pin (6) into the
hole (7) in the motor housing.
N Rotate the shaft, nut or cutting
attachment to line up the hole in the
fanwheel (1) with the stop pin (6).
N Push the stop pin (6) home until its
end is level with the blades on the
fanwheel (1).
The shaft is now blocked.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
N Screw the mowing head
counterclockwise on to the shaft (2)
as far as stop.
N Blocking the shaft
N Tighten down the mowing head
firmly.
NOTICE
Remove the tool used to block the shaft.
Remove the mowing head.
N Block the shaft.
N Unscrew the mowing head
clockwise.
Mounting the Cutting
Attachment
To Next Page
Loading...
