FSA 90 R
English
25
Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is at least 6 cm
(2 1/2 in) long. The blade on the
deflector trims overlong lines to the
correct length.
STIHL AutoCut
N With the engine running, hold the
rotating mowing head above the
grass surface.
N Tap it on the ground once – fresh
line is advanced and the blade on
the deflector trims it to the right
length.
Fresh line is advanced every time the
mowing head is tapped on the ground.
For this reason observe the mowing
head's cutting performance during
operation. If the mowing head is tapped
on the ground too often, the line limiter
blade will unnecessarily cut off unused
lengths of nylon line.
Line feed operates only if both lines are
still at least 2.5cm(1in) long.
Replacing Nylon Line
STIHL DuroCut
WARNING
Before fitting fresh lines in the mowing
head, set the retaining latch to ƒ and
remove the battery – this helps reduce
the risk of injury.
N Fit nylon line in the mowing head as
described in the instructions
supplied.
To Next Page
Loading...
