Stihl MSA 60.0 C User Manual

► Clean the area around the chain sprocket with
a damp cloth or STIHL resin solvent.
► Remove foreign objects from the battery com‐
partment and clean the battery compartment
with a damp cloth.
► Clean the electrical contacts in the battery
compartment with a paintbrush or soft brush.
► Fit the chain sprocket cover.
16.2 Cleaning the Bar and Chain
► Switch off the chain saw, engage the chain
brake and remove the battery.
► Remove the bar and chain.
2
0000-GXX-1215-A0
3
3
1
► Clean the oil port (1), oil inlet hole (2) and bar
groove (3) with a soft brush or STIHL resin
solvent.
► Clean the saw chain with a soft brush or
STIHL resin solvent.
► Mount the bar and chain.
16.3 Cleaning the Battery
► Clean the battery with a damp cloth.
16.4 Cleaning the Charger
► Disconnect the mains plug from the power
supply.
► Clean the charger with a damp cloth.
► Clean vents with a paintbrush.
► Clean the charger’s electrical contacts with a
paintbrush or a soft brush.
17 Maintenance
17.1 Deburring the Guide Bar
A burr can build up on the outer edge of the
guide bar.
► Remove burr with a flat file or a STIHL guide
bar dressing tool.
► If you have any queries: Contact your STIHL
servicing dealer.
17.2 Sharpening the Saw Chain
Correctly sharpening saw chains requires a lot of
practice.
STIHL files, STIHL filing aids, STIHL sharpeners
and the brochure “Sharpening STIHL Saw
Chains” help you achieve the right results. To
obtain the brochure visit http://www.stihl.com/
sharpening-brochure.
STIHL recommends you have saw chains
resharpened by a STIHL servicing dealer.
WARNING
■ The chain's cutters are very sharp. There is a
risk of cut injuries.
► Wear work gloves made of durable mate‐
rial.
0000-GXX-1219-A0
► File each cutter with a round file so that the
following points are observed:
–
Round file matches the chain pitch.
–
File from the inside to the outside of the cut‐
ter.
–
Hold the file at right angle to the guide bar.
–
Maintain a filing angle of 30°.
0000-GXX-1220-A1
► File down the depth gauges with a flat file so
that they are level with the STIHL filing gauge
and parallel to the service mark. The STIHL fil‐
ing gauge must match the chain pitch.
► If you have any queries: Contact your STIHL
servicing dealer for assistance.
17.3 Chain Brake Maintenance
The chain brake cannot be serviced by the user.
► Have the chain brake serviced by a STIHL
dealer at the following intervals:
–
Full-time use: every three months
–
Part-time use: every six months
–
Occasional use: once a year
17 Maintenance English
0458-022-8301-A 25

Stihl MSA 60.0 C Specifications

General

Brand	Stihl
Model	MSA 60.0 C
Category	Chainsaw
Language	English